here are certain timeless truths when it comes to printed circuits, and the more we stray from them, the more fervent our reaction when rediscovering them. Electrochemical deposition is going through such a revelation utilizing pulse reverse waveforms.
Electroplating was developed as a combination of Direct Current (DC) and a chemical bath. It was understood that this simple waveform and bath composition had considerable limitations. Numerous innovations followed to optimize the plating process for the desired deposit characteristics. There were advances in cell geometries, anode materials, temperature controls, monitoring, instrumentation and numerous others.
Read the rest of this entry »
If you’ve ever purchased inexpensive jewelry with a fine coating of precious metal, then you’ve witnessed the end result of electroplating. It’s an electrochemical reaction used to put a fine metallic coating on an object. Aside from making cheap jewelry, electroplating has important uses in the automotive industry for chrome plating, and in the electronics industry for optics and sensors.
The process of electroplating (also referred to as electrodeposition) is fairly simple. To start, a negative charge is placed on the object that will be coated. The object is then immersed in a salt solution of the metal that will be used to plate the object. From there, it’s simply a matter of attraction; the metallic ions of the salt are positively charged and are thus attracted to the negatively charged object. Once they connect, the positively charged ions revert back to their metallic form again and you have a newly electroplated object.
Read the rest of this entry »
The development of modern continuous sheet galvanizing lines has led to the disappearance of most of the old manual mills for galvanizing cut sheets. There are however still some machines that galvanize cut-to-length sheets; they use chemical pretreatment sequence similar to those for wire or tube galvanizing.
At the beginning of the line, the end of one coil is welded to the start of the next coil. Then there are two basic methods for continuously galvanizing sheet which differ in the way that the strip is cleaned before galvanizing-chemically or by thermal treatments. Coils of annealed cold reduced sheet may be fed directly to the galvanizing line, or alternatively, coiled sheet is continuously heat treated in the pretreatment line. After leaving the galvanizing bath, in which strip only stays for a few seconds, the surface is wiped to remove excess zinc and may be further treated to after the surface appearance, composition, smoothness or mechanical properties.
Read the rest of this entry »