When things go wrong on a zinc electroplating line, quick solutions can save thousands of dollars. If the answer is not pre- or post-treatment, the laboratory is the place to troubleshoot the plating bath. A quick analysis and a few hull cells may be all it takes to put the operation back on its feet. This paper deals with the investigative process in the laboratory.
First things First
Quick solutions to problems on an electroplating line can save thousands of dollars. Experience is by far the most valuable tool a troubleshooter can possess. So successful troubleshooting begins when the line is at its best! Build your experience by walking the line when everything is running smoothly. Take note of solution color, smells, gage settings, etc. Intimate knowledge of your plating line and its idiosyncrasies will expedite the solution to future problems.
Read the rest of this entry »
Electroplating is a process used to reduce the positively charged ions of a desired material, with the help of an electric current. The process also coats a conductive object with a thin layer of the material, such as a metal. Zinc electroplating is one of the most common forms of electroplating and popular because of its relatively low cost, protective nature and attractive appearance. The coating done through this process gives corrosion protection to ferrous components and it can give colors like gold, black or olive drab finish, by post treatment.
Read the rest of this entry »
The development of modern continuous sheet galvanizing lines has led to the disappearance of most of the old manual mills for galvanizing cut sheets. There are however still some machines that galvanize cut-to-length sheets; they use chemical pretreatment sequence similar to those for wire or tube galvanizing.
At the beginning of the line, the end of one coil is welded to the start of the next coil. Then there are two basic methods for continuously galvanizing sheet which differ in the way that the strip is cleaned before galvanizing-chemically or by thermal treatments. Coils of annealed cold reduced sheet may be fed directly to the galvanizing line, or alternatively, coiled sheet is continuously heat treated in the pretreatment line. After leaving the galvanizing bath, in which strip only stays for a few seconds, the surface is wiped to remove excess zinc and may be further treated to after the surface appearance, composition, smoothness or mechanical properties.
Read the rest of this entry »